Recent content by Dag05

Can I use this diagram and connect the blue and red points directly to my uniclip with the scematics you provided? That way the uniclip can comunicate with the progskeet 1.21 (the ribbon cable is apparently not compatible with the progskeet) This way I avoid soldering directly to the nand and...

I believe not at all, I have the skillset and the tools needed.. I just need the manuals or scematics where to solder to Unfortunately whenever I find a link to a tutorial for the progskeet the link is dead

this is the 360 clip with 48 pins

Thank you very much for the detailed tutorial! I shall test it out and give you feedback on it once I’m ready. First, I’ll have to tackle the issue of soldering my progskeet 1.21 to my 48 pin 360 clip.. It came with the clip which is attached to a green pcb that goes through a ribbon cable to...

Yes I could probably do this with teensy++.. but I have already shelled out 65€ for the 360 pin clip and the progskeet. Buying the teensy for like 35€ as Ive seen it on sites breaks the 100€ mark and shit is getting expensive at that point.. it really is a bummer

I learned about it here on the forums and suspected it after my ps3 got bricked. I learned of the fake bg toolset on a youtube video and left a comment stating the danger of following the instructions.. Thank you for your reply. I’ll look into the software side but first I’ll have to take a...

A couple of weeks ago I tried to jaibreak my near mint newly acquired backwardscompatible PS3 Phat Console with the dreaded russian BG Toolset.. at the time I didn‘t even know of the fake toolset and didnt think too much of it when it said fw 4.88 instead of 4.89 Long story short, it is bricked...