Recent content by Kostaslgr7

Raspberry Pi looks interesting too, I'll look into it, thanks!

Hello, thank you for your offer, teensy2ps3 seems interesting I'll probably order pcbs of that.

Okay then, waiting for advice, I'll attemp the rsx reball you suggest if nothing else comes up, just thought to let you know I just dumped the nor and it passed all 137 checks in Swizzly's dump checker

After SB uart loads up to "Safe mode", controller is charging then if I press ps button led 1 solid.

Hello, not sure exactly how but having controller connected by USB i get this different result in SB uart(hdd attached before supplying power to console) By the way I don't say that you're a "jump reball all" guy, I have a T890 and never used it on a PS3 Cell/RSX that's why I'm delaying it as...

Okay, what do you suggest I do now? I don't want to pull off rsx and reball yet, it's a bit risky. Again thank you for all your help.

What's your suggestion nowadays for nand writing?

Cool, I'll upload directly here, I do have an E3 Nor flasher, not much use for this specific console, also bought teensy 2++ from aliexpress but even though I have soldered 3v3 regulator on it and soldered 3v3 pads together and seperared 5v, light on it doesn't come on(comes if no reg is on and...

Wait, do you mean I should bridge them? What is that equal symbol there? Thank you. EDIT:Nevermind, here you go sir. It was the 2 round points you had circled here. Pay NO attention to the fataldown start error, I had not plugged psu cable all the way in. [/SPOILER]

Yes the system gets that far and I have sent the write command and confirmed with read, this is the hookup(while testing I only had right wire soldered to pad so no chance of shorting) and sadly pulled the pad because jumper wire a bit too big and heavy and wasn't as careful when trying to pass...

Hello, what do you mean you're not confident to test yourself? I soldered to the top 3v3 point and 0.75 to the right of the two pads, swapped rx and tx a couple of times to no avail,if you had a board how would you go about finding the sb rx tx? I'm dedicated to finding them unless it's a putty...

Sir if you see the pictures i shared above in post from your pictures i measured 0.75V and 3.3V points. I just want some guidance specifics on what to do with these pins, (solder them to normal rx tx pins and then write command "w 1202 02" and then open putty? thank you for your help.

I actually tried that and got back FFFFA501

Thank you for your help, so I solder wires from 3.3V to MB RX and from 0.75V to MB TX(or opposite) and leave my wires connected to mb points as before, plug power and then do I write something to the syscon or open putty first? A bit confused about that part, sorry. Also did I mess something up...

Found many half Volt points, no 3v3.