Recent content by lordpaladimo

  1. L

    PS3 Fault finding YLOD with the SYSCON - First steps and Error reporting

    First I would like to thank everyone here for their help, reading this forum I learned a lot about the PS3! @RIP-Felix, I fixed the checksum! Now the HD light blinks once and I have syscon errors again. Errors 1701 and 3034, GLOD on start. I'm thinking about reflowing the RSX and CPU. I even...
  2. L

    PS3 Fault finding YLOD with the SYSCON - First steps and Error reporting

    Rip-felix, Thx for help! I executed the wrong command to go to internal mode. I don't remember, it was something like EEP SET 3901 01 00 or EEP SET 3691 01 00. This command not return any errors. Then I saw that I executed the wrong command and executed the right command: EEP SET 3961 01 00...
  3. L

    PS3 Fault finding YLOD with the SYSCON - First steps and Error reporting

    Could an error in the command to correct the checksum cause the problem? Due to an error I executed EEP SET 3901 01 00 and the correct one was EEP SET 3961 01 00. No reflow or reballing in this console. Sorry for bad english! Thanks in advance!
  4. L

    PS3 Fault finding YLOD with the SYSCON - First steps and Error reporting

    1- Yes, HD connected. New and tested hard drive on PC. 2- Tested with HDMI and AV cable. 3- Yes, I tried the recovery mode, the console emits the beeps but there is no image and neither the Joysticks sync (usb cable) Apparently there is no power on HD, Bluray drive and usb. I tried to put a...
  5. L

    PS3 Fault finding YLOD with the SYSCON - First steps and Error reporting

    Friends, I would like some help. I have a CECHE with glod, after checking syscon errors, it was with 1701 error. I checked the NECTOKIN and they were visually burned, I swapped both the RSX and CELL (under the motherboard). After that, there were no error codes in syscon. However, the ps3...
Back
Top