Recent content by MannyMania

Hey did anybody 3D print a RP2040 case.... Post some pics.

Hey! Nice new look!! Welcome Back!!!:applouse:

Hey @aomsin2526. There is a small bug with the 4.92 CFW where the PS1 and PS2 options for screen smoothing and stretching are not being saved. It also effects the choice of Analog vs Digital controller as well. I noticed it in the qCFW first and then tested on a Fat PS3 to confirm it. I'm hoping...

Hi @Evilnat. I have a question about the PS1 settings. I've installed the latest qCFW on a Super Slim and noticed that PS1 settings for full screen and smoothing are not being saved. Each time you launch a PS1 game the settings have to be re-enabled. My PS3 Fat still had Rebug 4.86 and those...

I passed the wires by the network adapter. I forgot to take a picture. Here's how I ran them. I used wire wrap as it's very small.

Here they are:

I'm only getting one beep, not the three beeps. Thanks for the info :encouragement: I did some continuity tests on the CMD/CLK lines and they're good. The fail was at the connector I used for the CMD/CLK line to the Pico. ARGHHH!!! I Rechecked everything and now it finally powers up with the...

Hey @pstreecco Thanks for the help. It was a short on the SC_RX and SC_TX. I cleaned that up and now when I Plug in the power to the console the Pico blue light flashes once and stays on. When the console is powered on you hear the PS3 beep, and the blue light flashes three times and goes back...

Hey Galooko, Thanks for pointing out the TX and RX. :encouragement: Here's a question about the RP2040 Zero. I connect it to my laptop to load the BadWDSD_SW_x32_Zero.uf2 file. Right after it loads it disconnects as a USB drive and the built in led keeps flashing blue but the add on led on...

Hi all, I need some help. I'm using a Super Slim 4001C that I've updated from 4.90 to 4.92. I've also got HEN installed. How do you backup the flash? The PS3xploit page only does 4.10 to 4.85. Thanks. I went with using multiman and hopefully that will do. Time to take it apart and install the...

Cool!! I was holding off until the controller booting was fixed so this is great!! I'll give it a go. Thanks!!

I've got MediEvil Resurrection that does a blue screen overlay. I tried this fix and there was no change. Anyone know if this method fixes Medievil? Thanks. MM PS3 Fat, Rebug 4.82.2

Looking forward to it!! Thanks Joonie!!

:glee:....Yup...a noob... but not that noob. After the copy I did a soft boot and it didn't work so then a hard boot and still no joy.

Hey Joonie, it didn't work. I replaced the file but I'm still getting the video output setting error.