Recent content by Mystix

My PS3 was working fine before I flashed that OC CFW, it only showed the yellow light since then. I went up to 1.5v but it still YLODs I guess I need to find a way to restore the NAND then..

F6001 and F6302 are intact

Thank you Unfortunately my PS3 still YLODS no matter how high I set the voltage, I went up to 1,5v in .02v steps but no luck :( I think the only way to fix it now would be to recover the original NAND, right? Also to mention, the 2120 error comes up in ''packs'' of 10 when it YLODs ofst[...

I hooked up my syscon reader, changed the voltage to 1,25v, but it still YLODs. But now it flashes red when powering it up again, like when the checksum mismatches, this is what it says when typing eepcsum: eepcsum sum:0x3900 Addr:0x000032fe should be 0x198c Addr:0x000034fe should be 0x7115...

So basically I follow a RSX undervolt guide but instead of decreasing the voltage I increase it bit by bit until it doesnt YLOD anymore?

I think it was 750Mhz, but I am not sure anymore.

How would I go about this safely? And what value increments would you try so I don’t fry the rsx?

Hello everyone, So basically I have a bricked CECHC PS3 for over a year now that YLODs when trying to boot, because I flashed a CFW with a too high OC on it ( yes that was very stupid I know, you shouldnt oc a 90nm RSX at all...) I tried researching how to read the NAND of the PS3, replace the...

Hello, Can anyone link me a ofw 4.91 coreos.bin file? I cant seem to find any useful info on how to extract it myself. Thanks!

I think I need a tutorial on how to replace the lv1 in my nor dump, as I cannot find any info on how to do this.

Hey there, I kinda messed up. I went a bit too high on my cech-2004 and now it has a GLOD, no video no controller sync nothing. Is there a way to revert my ps3 back to working condition? I have a e3 flasher if that helps.