Recent content by Pelko

Does anybody have the problem with the unofficial controller not working inside popsloader? I have Logitech g-x2D11 cordless controller, but once I start popsloader, it stops responding. My second Logitech behaves exactly the same. Strangely, my noname aliexpress cordless controller works...

I am testing them outside of the board and on the right points (I hope so). Is it possible that so many readings are out of ordinary values?

Amazing. Thank you. Unfortunatelly, many values are totally out of place. Maybe I (total newbie) did something wrong and cant even read ohms (lol)? Could somebody inspect these values, please? VDDC 5.1ohm VDDR 1.17kohm VDDIORW 119.7kohm VDDA 89.6kohm VDDIO 18.71kohm FBVDD 698ohm

I just received 40nm rsx from aliexpress. How can I check if its in healthy state?

Hello again guys, I am back again and with my PS3, so here is the log of my Cech-B from japan market :) https://pastebin.com/5MzDxwCK Cant wait to see what you will find out

Anybody some config for Juiced? Game with jak v2 emu works without any graphical issues (as far as I have seen) but there is massive slowdown. Otherwise it could run great

Guys, you are amazing community. @sandungas right now I am away from the console for one week or so (today I left for bussiness trip). But once I will be back, I will do every single command or picture you need. I will hapilly contribute. What I know is that this console is directly bought from...

Cant edit post, so here is my bringup command with assembled console (just without bd drive) >$ bringup bringup [SSM] state: 0000 -> 0101 Bringup Mode #0 (0xFF) [SSM] ssmCb_OnStartingBePowOn() called. [SSM] First Boot. [SSM] Bringup mode : syspm_stat=00000000/00000000 [POWSEQ] PowerSeq_Setup...

I just checked, and it give me 2,7ohm, which according to your knowledge, should be great. Now I am starting to be confused :) Is this now deffinitive that it is not problem with my RSX? I understand, so I just soldered again the syscon diag and here is the log: The 3001 errors are all...

Thank you. Here is the error log. I cant get eepcsum because I already desoldered syscon diag. I have bad feeling that RSX chip is dead, and it was only revived with reflow. What if I tried to revive it again with hairdrier? It should do the trick. If ps3 will be alive again after that, it...

Three months ago I bought CECHB from ebay, with warranty sticker intact. Three days ago it died, short YLOD. When I opened it, it was delided. So I was pretty much scalped. Anyway, syscon is giving me error 3034 which means that bad BGA solder joint. My question is, how can I tell if it is...