Recent content by RGBeter

We don't have service manuals beyond SEM-001. If we had KTE-001, or anything after SUR-001, it would be helpful with CELL overclocking.

Classic flexio_id, I know that one all too well. Basically, your system cannot even begin to detect the RSX, and as such shuts down with a bit training error (3034) very quickly in the boot process. Unfortunately it probably needs a new RSX.

Huh, it seems like you're getting further than me with the bootloaders, I'm still stuck at sourcing an RSX to replace mine with, if that doesn't help me, then idk what you can do. Someone suggested the encoders aren't getting power for me earlier in the thread, you should check that out. If...

The system charges a DS3 just fine, but I can't sync any to it. Also a bit late to ask me to test since I already pulled the RSX since that's what some experienced members in the booter discord server thought the issue was, this PS3s gonna be a Frankie whether it likes it or not now! (So long as...

Already checked the codes, but I'll give what I thought of each 1004 I'm assuming was an improper shutdown, already swapped PSU, HDD, wireless card, memory card readers, and even disc drive (I know it won't read anything because daughterboard mismatch but it would still let the system boot or...

Hey everyone, ran into a GLOD system earlier today, Syscon codes are pretty much useless but they're here anyway, I also checked diagnostic output from the SB, and from what I see the system just, boots, no complaints, but I have no video output from either AV or HDMI. I inserted both logs, if...

Hmm, so all your codes are related to RSX_VDDC, with the system partially assembled, can you probe it with a multimeter? (RSX side of the caps) You should see it reach 1.2 volts for a time. Also, any photos of the installation would help significantly. If the caps aren't correct you'll end up...

Did you remember to bridge the two positive contacts on the RSX side, if you didn't you'd have errors similar to this since the RSX wouldn't see RSX_VDDC. Tantalizers are generally better than cheap ebay caps, actually, anything is, you should order parts from reputable sites like mouser or...

Hey everyone, just attempted my first RSX swap on a COK-001 board. I have good ohms on the board, or at least close enough where applicable like RSX PLL, but my system won't boot, here's my syscon bringup From what I understand, FLEXIO_ID should be solved with the 65nm training data, but it...