Recent content by sin89rus

thanks >$ eepcsum 00000000 # csum = 0x2958 ---------- fixed by w 7fe 58 29 ----------- If dump eeprom form syscon 2.5k model and write it to 2k model syscon, will it work? Or EEPROM contains info about power sequences etc? I cant find info about "can i just write CELL keys and other keys from...

any way to fix checksum on SW syscon?

doubt, scalped CELL or not? if scalped, so check all the BLUE resisistors down the board (under CELL), if some have less than 50-60 ohms (it can be shorted to GND on one side) and you get XDR link arror after 20sec of start, so you doing wrong reball without heatspreader, CELL just tricky to...

Corner of the cell to xdr memory damaged, or need to reball if not scalped yet (do scalp after reball, cause if you dont have exp. It will be difficult to reball)

yep, incompatible: 1 - back original syscon get A0403034 + A0404002 2 - retrain original syscon to 40nm RSX with commands PS3 Models: CECHLxx, CECHMxx, CECHPxx, CECHQxx, CECH-20xx Motherboards: VER-001, DYN-001 Syscons: SW-301, SW-302, SW2-301 40nm RSX Series: CXD5300xxx, CXD5301xxx, &...

Tried to swap CELL+SYSCON+NOR+RSX (45nm+40nm) from 2.5k model JSD-001 to 2k model DYN-001, get error 3001. Is something in syscon was changed on newer board? I mean i see that 2.5k have different ic's on 12v power good, like IC6023 was missing, but is that important? IC6023 is good on dyn-001...

thanks, work flawless 3013 ( A0213013 ) error - if there is no shorts like psdev says, so CELL reball will fix the situation

Is anyone know commands for syscon to back to 90nm. Trained and prepared it for 65nm, but need roll back.