Recent content by vldru

Upload the syscon log

Hello. I came across an unusual cechb00 board with only 35 days of battery life. I was only able to lower the SELL voltage to 1.1750 3V and the standard GPU voltage of 1.1150 1E. All attempts to lower the SELL voltage below 3V resulted in freezes in games like TLOU.

Thank you. The problem was solved.

My cechb00 console. Is it possible to install a drive with a different cechb and upgrade to ofw4.85 for a further bgtoolset patch?

Hello everyone. Can anyone tell me how to install evil492noBd on a console without a drive using the official 4.10 version?

Thanks for the advice, I did it and changed the firmware. There is no sound, but there is a toslink Where does the chain of connections begin? Why is the sound present in the optics, where is it formed and distributed in formats, and in which chip?

I am Russian, maybe there are difficulties in translation.

The console is not assembled, and both connectors are physically correct

Hello. Who can help with advice? I made Frankie 40nm cechc08, there is no sound via HDMI and multi AV, but there is sound via optics. What are the options for solving this problem, and where should I look?

Following the advice, I replaced 3520 with 3504, but when replacing resistors (2x3.9k, 2x2.2k) problems arose - the console refused to start YLOD 3034-4002 then 3034-4102. I decided to try to redo it on (2x4.7k, 2x2.2k), 0.950 for RSX 40nm and only after that it started. I don't understand why...

Your answer is closer to my question, VDDR voltage, I suspect it is the memory voltage.

I can assume that the RSX replacement was not made by Sony officially, but by a very professional service and they could not use voltage regulation, since Sony did not officially disclose data on SYSCON voltage programming, the first FRANKI PS3 were with an Orbis modchip. I measured the voltage...

Hello. I am addressing everyone who understands the topic. I want to clarify whether it is necessary to change the voltage controller after creating a 65nm frankenstein on the COK-002? I made voltage settings in syscon to 0.950v .

Normal CFW