Recent content by vyktormvmpay25

I'll look at ps5 soft leack and use same software for board viewer. Not anymore into console fixing but I'll give advice from my knowledge so far. Keep up with good work!

I'll dm his nand edit cant send so removed @Evilnat thank you!

@Evilnat can you please have a look on his dump? I just did correct some farts on ecc but can't be this, if there is something hw related we don't believe , no bad blocks, just ecc errors. He is good tech. Old clasic way didn't fix his issue , also metldr looking bit short then usually like...

If I manage to get hands on firmware then I will confirm if I can duplicate e3 flasher and make it work for nands as well. Atm I'm looking forward to reverse Ic pinout. Nands work to be read on 4 minutes and it's open source with stm32f103vc6t. Only problem is that still needs to desolder from...

I would like to see some uart log from ppl recover those brick units. I see people believe uart errors as 5fff or 3013 and 1001 think unit is bricked. I tend to believe a brick unit can stand in glod state without tristate. Or I don't remember exactly and need to check one unit. Anyway for...

Open project WIP. This would be a late ps2 mobo with socket in order to desolder EE ic from ps3 cok001 and test it on socket like ps3 rsx socket I've been testing already and working fine. I'm collecting info about revision first thing I need some people to share info about ps2 models EE. Late...

Assume you are good tech and know your tools for further reference and if you deal often with cok boards you can build for your lab one rsx universal rsx tester on socket. Best board and compatible with all 3 rsx is sem001. I believe slims and nor model are bit sensitive for length of cheap pogo...

Is there any bin as patcher for auto config of ps3 patcher? Wold be cfg and a patch bin but has to be built in a specific order I assume from x address add this length, and so on. The hardware side we have focused last year in research of a flasher and ways to test in parallel nands (tied to...

I've tried to help him guys but I know less , Ive seen those 4 cell errors areas but i dont own that much knowledge for dex,compared with only one unit ive did as Frankie,as example how to swap data inside dumps I've made one record,ppl can skip first 15 mins https://s.go.ro/xadbzt2k

Yes lan cable is ethernet.

Run it from lan cable, set up browser homepage blank, add to bookmark only exploit page and then go straight to it. It is always work for me. Run it as http if https fails.

What type of nor is that you have? Keep it as it work. You have a valid dump can always be repaired. Don't fix it if ain't broken. But if you still have your thoughts bother you pay me for your time you spend to swap it.

Remainder nands have bad blocks most often from write allocations. Error correcting codes (ECC) are used with NAND flash memory to detect and correct bit errors that may occur with the memory. NAND flash memory bit error rates increase with the number of program/erase cycles and the scaling of...

I have not went to deep into those but yes it could be there, Idk, more things around overclock thread probably. Didn't test that neither.

You don't understand why? Try w 7fe 26 47 We have a limit of 10 bits to SW models. Read inside script and understand what is happening there.