Recent content by Yoplay

Pretty sure , on 2504 it's a HDD but on 3004 it's a brand New 1Tb SSD ....and it works on ps3 fat cfw. But not exact same behavior on 2504 fatal crash with reboot, on 3004 (SSD one) black screen...have to "hard reset" console. But both are rebooting without problems. Don't know how to send u...

Agreed to the "moron's" thing, when u put yourself at risk you've got to assume consequences... Some news about testing qCFW on my PS3's, so far so good : 3004B is working well 2504A is ok. Got another 2504A qCFW went unstable, manage to dump syscon errors: 1701-14FF then 3034, 4421...

Je confirme : tous les modèles cech 3004 A/B ont une CM kte-001... "For sure" all CECH 3004 A&B got KTE-001 motherboard... En dynamique avec température de consigne a 60°... Variable mode on mine with max température 60°. I got this kind of problem too...i think old HDD maybe guilty i...

J'ai deja posté les points de soudure pour la 3004B sur ce post....J'ai acheté les 3 PICO pour moins de 13 € (4.30€ l'une)... I already post solder points for CECH 3004B on this post...and i bought 3 pico for less than 13€ (4.3€ /each)... Pour CCAPI je ne sais je ne l'utilise pas, ARTEMIS et...

Oui, comme te l'a confirmé Metek tu peux refermer la console, la puce est autonome pas besoin d'y avoir accès en permanence. Mes 2 PS3 sont flashées et refermées, fonctionnelles comme avec un CFW. Yes, as Metek confirmed, you can close the console; the chip is self-contained and doesn't...

Hi again, Done again on a JTP-001 CECH 2504A, solder point are the same as KTE-001. strange behavior when installing qCFW, it takes like 40 minutes , then reboot in safe mode...so i reinstalled 4.92HFW then hen but when i want t install qCFW it asks me to reinstall firmware.... So reflashed...

Hi, Work done, Found the clue : it was clk resistor, slightly broken, when pushing the probe to test i got the 55.5 ohms...while on the wire other side 1.46 Mohms...something stupid as always... here's my wiring, everything went fine qCFW installed and working great. Thanks aomsin for the...

Well...weird I tested one side of the wire (soldered to the resistor) and i read the 55.5...when i i test the wire on the pico side i read 1.45 Mohms 0 ohm on each side of the wire ... Gonna check tomorrow each pins and connections...and keep u in touch...Already check 10 times. By the way...

Hi, I'm actually working on a kte-001 (2504A) 4.92 hfw installed so is hen 3.4.1 and stagex. Flashed uf2 file ok. Chip soldered....led becomes solid and ....glod when power on...clk and cmd checked cmd =55.5 but clk =OL Desoldered cmd and clk and test resistors both Ok with 55.5 Ohms.... Any...

Issue fixed Thx 4 help...xD

Hi, A bit new on the forum, came here cause i got problem on my slim. SAD 001 Mobo no Sync on safe mode, cable ok on my fat and DS4 too. Tested : -USB port no shorts, 5v ok -southbridge all capa and resistors tested (On board) No shorts on any nearby the SCEI BGA Does anyone have a clue of...