teensy

I have a 2001a system with a mis matched disc drive. I can't even install ofw, as I get the error code for bad drive. I installed a teensy and used Norway to patch down to 3.55 but when I boot it's asking me for a 4.90 firmware for some reason. I've tried 4.90 noBD evilnat but it says the...

So after I built my NAND teensy flasher, I decided to go with NOR. I decided to setup with 360clip + Teensy++ 2.0 with 3.3v regulator, just like I used to for my NAND one. After making the flasher, it seems I cannot find anything about how to use the NOR flasher without powering on PS3. It...

Hi, I am trying to read NOR TSOP48 flash not from PS3, but I am trying to use the same method as in this tutorial: https://www.psx-place.com/threads/chapter-iii-nor-downgrade-teensy-flasher.838/ My TSOP48 does not have so many pins as TSOP56 in tutorial. It is missing A20/A21/A22/TRISTATE...

Hi everybody, please help me i’m noob. I have a PS3 FAT Nor type, Cech J04, minimum firmware installable 2.16. I got this problem: while i was trying to switch from HFW 4.84 to CFW i bricked my ps3 (NOR FLASHED BAD). Briefly, i had to install twice hfw 4.84.2 to load both ROS (ROS0 e ROS1) with...

Hi, After looking far and wide for solutions to my problem, was unable to find any. Hence my thread. Some time ago I purchased a PS4 that showed signs of the NOR ROM chip being corrupted. I found three videos Andrew Paul made on YouTube () explaining on how to build a Teensy++ programmer board...

Hey, I connected my teensy to my ps3 (slim nor). and bridged the v3.3 and soldered the voltage regulator. But when i connect it to my PC i get this message: If i power up my ps3 and then connect the teensy it wont be recognized either. Everything works fine on v5 (it shows up as a COM port)...

Here my GUI for NORway/NANDway/SPIway : Download WAY-launchers : https://github.com/littlebalup/WAY-launchers/raw/master/Releases/WAY-launchers%20v2.05.exe