Recent content by jigzat

  1. J

    PS3 Fault finding YLOD with the SYSCON - First steps and Error reporting

    can someone help me identify this part? is L6201 and L6202 in service manual, is it an AC/DC? I bought another CECHA01 and that one one has a crack in this part (picture from other board)
  2. J

    PS3 Frankenstein PHAT PS3: CECHA with 40nm RSX

    Thank you very much :eagerness: I don't want to abuse your time but by any chance do you have a link for the service manual of the JTP-001(Google is not cooperating) or do you know if they are the same in that board? UPDATE: So I was checking old pictures before the swapping the RSX and it...
  3. J

    PS3 Frankenstein PHAT PS3: CECHA with 40nm RSX

    I'm back peeps, so I finally had time to test everything again after changing all the caps and test it I got the 3004 error again I opened it up and I found something was missing. Do you guys think this could be cause? I bet it is! The service manual says is part C6019 but I don't seem to...
  4. J

    PS3 Fault finding YLOD with the SYSCON - First steps and Error reporting

    So I just checked and one of the blue wires was very loose, it was not lifted but I moved it and it didn't seemed it was held properly in any case I will install the RipFelix tantalizers
  5. J

    PS3 Fault finding YLOD with the SYSCON - First steps and Error reporting

    Thank you very much for the reply. I was actually planning to replace all the caps because that job was awful (long story short my original PS3 got lost or stolen at certain repair center and they gave me this one as compensation ) but it was working fine with this caps (albeit the high...
  6. J

    PS3 Fault finding YLOD with the SYSCON - First steps and Error reporting

    Hello everyone, so I finally got my PS3 back (6 months) after the RSX swap but I'm getting error 3004 in the logs. I'm in Colombia so there are very few places where I can do it. In my case I made the resistors changes in the back by myself and sent the board to a good repair shop where they...
  7. J

    PS3 Frankenstein PHAT PS3: CECHA with 40nm RSX

    Can someone help me out. I damaged the R2153, I have the JTP-001, can I salvage one from that board? I cannot find the schematics for that board. The other alternative is to take a resistor from a PS2 GH-023 board that I have around and of which I have the circuit diagram, would there be a...
  8. J

    PS3 Need few clarifications regarding PS3 GPU Swap

    So I finally found the answer unfortunately I cannot add links but it is in the original thread page 76
  9. J

    PS3 Need few clarifications regarding PS3 GPU Swap

    Hello, everyone special thanks to RipFelix for all the job around the PS3. I'm going to attempt to do a Frankie and I wan't to kindly ask anyone who has done it a few clarifications. Here are the facts: I'm in Colombia, no one here knows how to do it, and sending it to the US is extremely...
Back
Top