Recent content by OneFix

Check this RIP-Felix’s tutorial: https://www.psx-place.com/threads/syscon-tutorial-windows.41664/ The last part shows you how to check SB uart.

If it boots even for 5 seconds then check SB uart.

Fixed by swapping 40nm RSX.

CECHC console late YLOD. Syscon shows full list of 1701 error codes. However, SB uart shows lv2(2) rsx driver assert failed: device/fb.cc : 41. Is this faulty RSX or could this be broken bga bumps under CELL as well?

UPDATE. Replaced CXD9208 ic and now i am able to open ingame menu. However, no ps2 logo using disc or isos. Screen blinking twice while booting ps2 game. UPDATE. Replaced EE GS, but no fix. UPDATE. Replaced new 40nm RSX, no fix. Still black screen with ps2 games. NoPS2_Menu UPDATE. Replaced...

I have same problem with my CECHB (NTSC-J) 40nm frankenstein console. Only difference is that i am not able to open ingame menu and need to force shutdown console. I cannot see white ps2 logo, just black screen. However, I am able to sync controller. Could it be also bad EE based on these...

UPDATE. Swapped 40nm rsx and HDMI IC also. Same error codes A0802022 and GLOD. Need to investigate more on DVE/hdmi circuit.

Just received CECHA console with YLOD and full list of 3034 errors. I reflowed RSX and console booted, however cannot get signal to the screen via hdmi or AV (GLOD). Now I get full list of errors A0802022 (DVE errors). I already replaced CXM4024R MultiAV controller chip from donor board, but...

I have the same problem, full list of 3040 errors with CECHA console. Did you have backup of the working nand dumps? Or did you just redump the data back to the new NANDs? @luvbuckets

Thanks for the fast reply!

Would RSX work properly even I have ripped "signal" pad from the board in the RSX pinout area? In my case pad AW10.

Thanks for the comments @vyktormvmpay25 ! Console does not enter to recovery/safe mode. I have now reballed cell, but no differences. I am using ACHI IR PRO station with elstein's heaters (2400w + 400w). Next I will check corruption of nands.

CECHA GLOD problem. Only one beep. Replaced RSX 40nm twice and same problem. Does anyone know the solution? As you can see below SB uart is very short? Defect CELL? SB uart: Boot Loader SE Version 4.8.9 (Build ID: 5366,50740, Build Date: 2022-02-04_12:51:26) SDK Version: 489.000 Copyright(C)...

UPDATE: Here is bringup log. Booting sequence is normal without HDD? Syscon firmware is v1.0.0_k1. So conclusion is that the syscon firmware could be the problem, because I can see 40nm support added in v1.5.1_k2 version? bringup [SSM] state: 0000 -> 0101 Bringup Mode #0 (0xFF) [SSM]...

Due to YLOD CECHA console, I reballed CELL and changed RSX to 40nm with ORBIS mod. Now console boots, but it indicates GLOD. When I try to put console to safe mod, i can hear second beep. The problem is there is no signal. I cannot see any error codes via syscon UART. I would like to confirm...