Recent content by unseen

Nvm, bgtoolset did it.

Hello. I have a super slim 4003C on 4.91 HFW, HEN installed. I'd like to dump and keep in a safe place the 16MB flash just to be on the safe side. As far as I know, flash dumper only works up until 4.88? Please help me, guide me how I could do it. Thanks.

A delid would fix it. CPU has almost no thermal paste over it.

I did already 2 delids. First on a 2500, than on a CECHC. Both went successfully. Used a (rather crappy) nail file, as per NSC videos. The trick is that the cutting surface has to be super thin. At least the part that cuts the silicone. Otherwise the pressure (excerted by the silicone) will be...

I would double check the placement of IHS's. Especially over the RSX. Even my non delided slim works much cooler, quieter than yours. You did something wrong. Make sure you completely clean the old thermal glue from RAM's and IHS too. Put the IHS's back onto the heatsinks as close as the...

Hi. My question is, if I reformat the hard disk from XMB, (to get back all the lost disk space) what will happen to my CFW? I really don't want to reflash a custom firmware. I don't care to lose all homebrew, I can reinstall. Thank you.

PS3 superslim. I was diagnosing some WiFi issues with only the standby power connected. The main 12V was not connected. I got the following syscon error codes: 0xA0003001 So a defective PSU, or missing/shorted 12V rail gives this error.

Maybe this one?

Hi. Does anybody know what is common between wired and wireless network on the PS3? I have intermittent problems with both, and cannot find a pattern. Wireless networks ocasionally appear while doing a scan, but usually I get none. There are times when I get a LAN cable unplugged message. I...

I have a super slim with almost the same symptoms. However mine also has LAN connection problems. WiFi is also hit and miss. Sometimes it works and sees networks, but mostly not. Controller usually can connect and works, but sometimes it has difficulty connecting. The console usually freezes if...

Hi. Does anybody know if on NPX-001 board, the ethernet IC and the wireless module share the same power supply line? Same regulator(s)? Thanks.

Would it be possible to add CELL and RSX temperature displays to the toolset? Useful on stock OFW consoles.

I've recently bought a superslim console that has some problems with the wireless part. Sometimes the controller has difficulties to connect after pulling out the usb cable. Sometimes it doesn't connect at all. Whet it does, it works ok even from large distance. The bigger problem is the wifi...

I also have to use convoluted methods to read that stupid site...:sang banghead:

Brawl in Cell Block 99