Kleon1876
Member
I bought a used 3001b. The hdmi port was damage no picture. I opened it up, replaced the hdmi port, booted and it went to the install screen u get if u pull power off mid firmware install. Got to 6% and got the error. I tried everything. Removed the cmos. Put it back in. Put in a working drive, reformatted, usb ofw 4.86, got to 6% same thing. Tried a different bd, same thing. Tried a different power supply, same thing. What can it be. Tried multiple usb sticks with the ofw. Tested the sticks and installed fresh 4.90 on a working slim. The bt and wlan cables are connected. The bd cables are connected. I can't figure it out.
so according to the install breakdown, and the error code, and since i get stuck at 6%, i think this is where the error occurs. why?
so according to the install breakdown, and the error code, and since i get stuck at 6%, i think this is where the error occurs. why?
| Update Package Revoke list read package revoke list package (576 bytes) elapsed = 6 msec update package revoke list elapsed = 331 msec Update Package Revoke list done(0x8002f000) | RL_FOR_PACKAGE.img copied from PUP to trvk_pkg | |
| Update Core OS Package read core os package (5193774 bytes) elapsed = 324 msec update core os package elapsed = 1965 msec Update Core OS Package done(0x8002f000) | Core OS package (CORE_OS_PACKAGE.pkg) is unpkg'ed from PUP and written to ros |
Last edited:
