finalman
Member
I designing a printed circuit board to restore hard drive IDE connector on the rear of v12-v13.
While at the same time I'm designing a 3d printed shape to go around where hard drive IDE connector sticks from the rear of the PS2. I am designing my 3D printed shape to resemble the PS2 FATs network adapter.
WHAT I NEED TO KNOW:
See the attached picture.
I need to know the measurement between the side of the Network port and the side of the dialup port as seen seen with red lines in the picture.
I need this because I want to make sure my 3d printed shape will not collide with the HDMI ports mods from pixel FX and the yet to be released PS2 Digital from citrus3000psi that both use the dial-up port to house a mini HDMI port.
I live in Australia so we never got the PS2 with the dialup port. I want to eventually sell my hdd adapters so I want to make sure my design suits all launch model PS2 slims.
While at the same time I'm designing a 3d printed shape to go around where hard drive IDE connector sticks from the rear of the PS2. I am designing my 3D printed shape to resemble the PS2 FATs network adapter.
WHAT I NEED TO KNOW:
See the attached picture.
I need to know the measurement between the side of the Network port and the side of the dialup port as seen seen with red lines in the picture.
I need this because I want to make sure my 3d printed shape will not collide with the HDMI ports mods from pixel FX and the yet to be released PS2 Digital from citrus3000psi that both use the dial-up port to house a mini HDMI port.
I live in Australia so we never got the PS2 with the dialup port. I want to eventually sell my hdd adapters so I want to make sure my design suits all launch model PS2 slims.
Attachments
Last edited:
