PS3 need coreos ofw 4.90
- Thread starter epervier
- Start date
Charles_n_town
Senior Member
You can get it from the update pup. You can decrypt it easily with PUAD, which is an app by @Evilnat . I don't know what you're planning, but be careful.
zecoxao
Developer
hi,
thank you but I can't downlod the file, the page is not loading
hi,
i tried it but it gave me an apk file while i need bin file. I need it for a bad dump which has ros0 hash and ros1 hash "red"
Last edited by a moderator:
zecoxao
Developer
thank you
zecoxao
Developer
good luck my friend. try not to brick
I'm trying to unbrick a ps3. i will try to explain the problem, excuse for my poor english i'm in France.
I bought the console with no hard disk, when i tried to install an ofw it was not found. i then tried rebug 4.84 and the installation went fine but the console froze, i restarted it but after about 30 secondes it went off.
With the tristate point connected to ground i was able to make a dump it with e3 flasher. i tried to follow a tutorial to repare it with no success
zecoxao
Developer
we can take this to dm on discord or telegram
i'm zecoxao#0254 (discord) or @zecoxao1 (telegram)
I don't use telegram and others, if you want to help me this is the dump.
thank you
https://mega.nz/file/D3hQTChb#C-zlHmM-YcBWkscobfX3SLbqvGp9TyNXaRxJAmdbsaU
Thank you, should I solder the nor tristate point to the sbe point on the e3 ribbon and do the flash under "flash fun" mode ?
zecoxao
Developer
Solder the tristate to ground instead (any of the pins that mark as ground on the ps3 pin layouts) and use the other mode instead. don't be stupid and never use flash fun mode.
I thought flash fun mode is used when the ps3 goes off by itself.
tristate soldered to ground, all pins down, after flashing and desolding tristate the console still goes off after about 30 secondes, I think I will sell it for parts
zecoxao
Developer
did you verify that what you wrote was proper?
zecoxao
Developer
