PS2 OPL Freezes and games not loading over ETH

[Raptorbk]

Hi! I have issues with my OPL setup, i'm using the latest beta, 2221. My setup consists on a Raspberry pi with the SMB server, and a usb pendrive to store the games, some games work fine but for example Motorstorm Artic Edge freezes most of the time, in general it gets stuck on the Sony screen at the beginning, Killzone works fine but if i stay on the menu i can try to save and it will get stuck forever.

Are these issues normal?

I have a 9xxx PS2 Slim Model

My raspberry pi is not undervolting, this is my SMB configuration:


My fstab

proc            /proc           proc    defaults          0       0
PARTUUID=e30563eb-01  /boot/firmware  vfat    defaults          0       2
PARTUUID=e30563eb-02  /               ext4    defaults,noatime  0       1
# a swapfile is not a swap partition, no line here
#   use  dphys-swapfile swap[on|off]  for that
UUID=7D7F-FB16  /PS2SMB  exfat  defaults,nofail,uid=1000,gid=1000,umask=000  0  0

vcgencmd get_throttled returns throttled=0x0

 

[jolek]

Motorstorm Artic Edge freezes most of the time

Did you try any compatibility modes with this game?
E.g. 1+2+6.

 

[Raptorbk]

Yes sir i did, i think the issue may be on the Raspberry Pi itself, i mean it has a default installation of raspbian 64 bits and SMB configured pretty much standard. I just set up my windows pc as the Server and for now it is working without problems, i'll come back in a few hours to report again but i think that's it probably.

 

[volventura]

I don't have an SMB setup, but way back then when my Ps2 freezes on an internal SSD that's almost newly bought, I found out that I had to replace the PSU inside.

Maybe that can be a hint.

 

[Raptorbk]

I

I don't have an SMB setup, but way back then when my Ps2 freezes on an internal SSD that's almost newly bought, I found out that I had to replace the PSU inside.

Maybe that can be a hint.

It was the Raspberry Pi at the end, i switched SMB server to my pc and it works just fine, it is weird because i think i set up everything right and it is not undervolting, but well it is a quite old Raspberry Pi and it is not in good shape so that may be it. Thanks everyone!