Orski
Forum Noob
I successfully managed to install FMCB on my memory card and it booted normally, no problems. OPL ran perfectly I set up my settings, saved them, connected to my smb share and made sure it was seeing it.
Then I went to my pc and downloaded the first game I saw on Vimm, which is Escape from Monkey Island (USA), went back to my PS2, booted it, OPL opened normally with all my settings saved, I opened the game and played for a bit then turned off the PS, after a bit I wanted to continue playing, booted it up, opened OPL but unfortunately nothing, I went and deleted the config file for OPL through wLaunchELF, and OPL opened again, but of course my settings were missing.
I think I should add that my MC wasn't in the greatest condition (It was corrupted and I had to use MCAnnihilator to make it work) and I had a clone Matrix Infinity modchip that I had to physically disable due to it not allowing me to boot from the MC.
So if you have any ideas I could try or maybe something I can do to troubleshoot why OPL configs are getting corrupted, it would be greatly appreciated.
Thank you for your help!
Then I went to my pc and downloaded the first game I saw on Vimm, which is Escape from Monkey Island (USA), went back to my PS2, booted it, OPL opened normally with all my settings saved, I opened the game and played for a bit then turned off the PS, after a bit I wanted to continue playing, booted it up, opened OPL but unfortunately nothing, I went and deleted the config file for OPL through wLaunchELF, and OPL opened again, but of course my settings were missing.
I think I should add that my MC wasn't in the greatest condition (It was corrupted and I had to use MCAnnihilator to make it work) and I had a clone Matrix Infinity modchip that I had to physically disable due to it not allowing me to boot from the MC.
So if you have any ideas I could try or maybe something I can do to troubleshoot why OPL configs are getting corrupted, it would be greatly appreciated.
Thank you for your help!
