Hello 
i have that USB to TTL board:
https://i.imgur.com/G5Z39sV.jpeg
https://i.imgur.com/lXPUzNw.jpeg
https://i.imgur.com/Hy0Kqpv.jpg
and these cables:
https://www.aliexpress.com/item/100....order_list.order_list_main.23.63443696436Tcj
my PS3 board is that one (DIA - 001):
https://i.imgur.com/9UdF9fb.jpg
but from the online guides there are explanation all in the same video for many revisions of ps3 board and i feel very confused after watching the movies, i don't know where to weld the cables.
from this screenshot that i took:
https://i.imgur.com/to7zdWF.jpeg
i have to weld 3 cables to:
SC_Tx
SC_Rx
SC_Diag
and here my questions are:
1) what colours do you advice me to use ?
2) and i don't understand, i have to weld another cable to GND where is circled ?
3) as output i make sure that there is the female part of the cable to which I can then connect the male?
like that : https://i.imgur.com/PKJXQL6.jpg
4) another thing that i have noticed is that in the video i saw online they use an USB to TTL board where there are empty slots, like this one, where they connect the ground : https://i.imgur.com/HtJb0l5.png
in my case, my board don't have these empty slots, so i can connect the GND to that pin:
i have opened another theared because the old was to general about what board there was possible to find in different PS3 revisions. Now here is just about how i can check the errors codes for the DIA-001
i have that USB to TTL board:
https://i.imgur.com/G5Z39sV.jpeg
https://i.imgur.com/lXPUzNw.jpeg
https://i.imgur.com/Hy0Kqpv.jpg
and these cables:
https://www.aliexpress.com/item/100....order_list.order_list_main.23.63443696436Tcj
my PS3 board is that one (DIA - 001):
https://i.imgur.com/9UdF9fb.jpg
but from the online guides there are explanation all in the same video for many revisions of ps3 board and i feel very confused after watching the movies, i don't know where to weld the cables.
from this screenshot that i took:
https://i.imgur.com/to7zdWF.jpeg
i have to weld 3 cables to:
SC_Tx
SC_Rx
SC_Diag
and here my questions are:
1) what colours do you advice me to use ?
2) and i don't understand, i have to weld another cable to GND where is circled ?
3) as output i make sure that there is the female part of the cable to which I can then connect the male?
like that : https://i.imgur.com/PKJXQL6.jpg
4) another thing that i have noticed is that in the video i saw online they use an USB to TTL board where there are empty slots, like this one, where they connect the ground : https://i.imgur.com/HtJb0l5.png
in my case, my board don't have these empty slots, so i can connect the GND to that pin:
i have opened another theared because the old was to general about what board there was possible to find in different PS3 revisions. Now here is just about how i can check the errors codes for the DIA-001
