PS3 Ps3 FAT CECHE01 firmware problems

[Fedex]

Hi im having trouble with a semi bricked or bricked (i dont know really) ps3 ceche01 the problem is that it got stuck in a software update loop because a bd rom drive issue, fixed that and then it went instantly into ylod without an error and it throwed ERROR WRITING EEPROM! in syscon bringup.

What i tried:

-Flashing both nands to 4.91 (patched using ps3dumpchecker)
-Flashing to 3.55 and tried fsm with teensy (didnt even enter fsm)

With the nands patched it stays on and then shuts off directly to a red light, if i go to safe mode it enters it but always asks for 4.78 (the version that was trying to update). If i put the usb with the update and try it always gives the error the data is corrupted.

Thanks

 

[Zx6r]

Fsm is not available to NAND models only nor chips and have you tried installing a NOBT frimware from evilnat OR Rebug

Fsm is not available to NAND models only nor chips and have you tried installing a NOBT frimware from evilnat OR Rebug

NOBT frimware is when your ps3 disk reader is broken that's what caused the update loop try downloading a nobt frimware and see if it'll fix the update issue

 

[Fedex]

NOBT frimware is when your ps3 disk reader is broken that's what caused the update loop try downloading a nobt frimware and see if it'll fix the update issue

tried everything, noBT, noBD and nothing worked, and i think you can enable FSM in NAND models, NSC did a video about that and i followed that video . Its stuck at 4.78 i have the dumps if someone can help but it says its all OK

 

[Zx6r]

tried everything, noBT, noBD and nothing worked, and i think you can enable FSM in NAND models, NSC did a video about that and i followed that video . Its stuck at 4.78 i have the dumps if someone can help but it says its all OK

Can you buy an e3 flasher from Ali express or any where?

Can you buy an e3 flasher from Ali express or any where?

Use this way as a last resort if you have no soldering skills you can take it to any pc repair place and tell them to solder the e3 flasher to the motherboard but you need to give them a pdf showong the solder points

tried everything, noBT, noBD and nothing worked, and i think you can enable FSM in NAND models, NSC did a video about that and i followed that video . Its stuck at 4.78 i have the dumps if someone can help but it says its all have you tried recovery mode?

 

[Fedex]

Use this way as a last resort if you have no soldering skills you can take it to any pc repair place and tell them to solder the e3 flasher to the motherboard but you need to give them a pdf showong the solder points

e3 flasher doesnt work in NAND models, i said i have a teensy and i already flashed nands so i can flash them without any problem, but it doesnt fix anything its still stuck at update and failing at around 4% and i already checked that the bd works and wifi also.

 

[Zx6r]

e3 flasher doesnt work in NAND models, i said i have a teensy and i already flashed nands so i can flash them without any problem, but it doesnt fix anything its still stuck at update and failing at around 4% and i already checked that the bd works and wifi also.

Have you tried another flash drive?

 

[Fedex]

Have you tried another flash drive?

yep, i tried that flash drive to flash another ps3 and it worked fine, i changed everything, hard drives, flash drives and nothing