Sry for the "engrish" (and partly for google translate), but hi everyone.
After using PMAP and calibrating new laser, my SCPH-39008 was stuck in testmode without grounding RMC pin in mechacon.
1)Tried to restore EEPROM - N/W
2)Replaced the battery - N/W
3)Checked resistance between RMC and ground - 10k Ohm (like in service manual, there is resistor 10k Ohm RB602 between RMC and ground).
Any ideas how to fix the problem?
After using PMAP and calibrating new laser, my SCPH-39008 was stuck in testmode without grounding RMC pin in mechacon.
1)Tried to restore EEPROM - N/W
2)Replaced the battery - N/W
3)Checked resistance between RMC and ground - 10k Ohm (like in service manual, there is resistor 10k Ohm RB602 between RMC and ground).
Any ideas how to fix the problem?
