remarry

I recently acquired two decha00a consoles from someone. They both were YLOD when I received them. I was able to bring them back to life by retrofitting a 40nm rsx into them. I'm now facing a problem with the bluray drives on both consoles. I have a feeling these aren't the original drives to the...

Soooo I opened a few ps3s at the same time to repair the ylod and I labeled all the bd drives so I knew which one went to which motherboard but the labels fell off so now they're all mixed up. I've tried every combination of board to drive and none of them boot games, bd movies, DVDs, or ps1...

Hello Everyone. I hope you guys are doing good!! (god bless everyone) Today i m here to request a help from you. I ll tell the hole STORY: I bought a ps3CECHA00 from Japan, this cosoles arrives me withou BD(Bluray Driver) so i bought one and connect to motherboard. So i needed to start the...

Hello all - I purchased a BC PS3 with a broken BD drive, based on the issues loading iso's it seems like the logic board was also faulty. I installed a known working BD drive and attempted to remarry following various guides but keep on running into issues. When in FSM mode, the drive can read...

Hi everyone, I've recently bought a Phat PS3 with a defective disc drive, got it for just 15€. I purchased a new disc drive because I didn't have the expertise/nerves to swap the laser. After installing the new drive with the old controller board the PS3 still refused to play anything, so I...

I had to buy a new BD and I'm trying to remarry it on a FAT CECHK01 with firmware 4.87. The connector on the old daughterboard broke so I can't use it and install it on the new BD drive. OFW is 4.87 so The only CFW I can get on it is 4.87.2 Evilnat Cobra. All the others say file corrupted when...

Does anyone know how I can fix this connector? I don't think I can solder it. Someone who is better than I am might be able to but I don't have the patience. I have to remarry the new one if I can't fix this one and after reading through the threads here I'm sure I'll struggle to perform the...

I have a CECHA motherboard and need to remarry a BD. I've removed the nands from the motherboard and read them with a teensy++/TSOP48 wire wrapped board. I had very little repeatable dumps using the clip, now all my dumps are 100% identical (provided I do nothing else on the laptop until the...

As the title describes, I am on Rebug 4.85.1 no BD and I am getting the following error when I try to do the Remarry Bluray Drive in Factory Service Mode (FSM): sys_storage_open err: 80010006 CEX_drive_init() failed As far as I can tell, everything is well attached to the PS3. I have tried 4...

First of all you can't launch homebrew,games,apps any kind of program all will give blackscreen even toggle QA Flag will give blackscreen so you can't install lower firmware (noBD versions) if your console is not already QA flagged you can follow on of those two method depending one what cfw you...

Hi everyone, I got this issue:i got a ps3 fat OF 4.84 with Bd not working. Today I ve update to HFW 4.82.2 and now i would to remarry the BD and after it i would to update to CFW 4.84 rebug. Anyone knows how remarry bluray? Ps: i haven't e3 flasher for an eventually downgrade n i won't buy it...

bought a ps3 that didn't have blue ray drive. replaced the blue ray with same model but cant get original IDPSET. is there anyway to remarry the blue ray drive without out this. i know there married so cant i get it off the motherboard some way instead of the original blue ray

Hi, I'm having trouble with my PS3. I flashed the nor chip and used a rogero 3.55 downgrader on my 2001-B model but was unable to toggle the qa, update to another cfw, remarry my bd, installed 2 other hard drives, nothing. So, I tried to re-flash the chip now all I get is the 9.99 or higher...