Hi all, I've got a proto slim here that seems to have been flashed with the wrong firmware.
I got this unit as is and it's not possible to get into any sort of recovery mode, the unit beeps a few times after turning on and shuts down again. Syscon showed no errors but the Southbridge uart confirmed that an invalid kernel image is present
Is this possible to recover? I do have an xgecu external programmer so I would be able to desolder and write to the chip but without the backup is it even possible?
I got this unit as is and it's not possible to get into any sort of recovery mode, the unit beeps a few times after turning on and shuts down again. Syscon showed no errors but the Southbridge uart confirmed that an invalid kernel image is present
Is this possible to recover? I do have an xgecu external programmer so I would be able to desolder and write to the chip but without the backup is it even possible?
