Hi everyone!
Yesterday I repaired a PS3 model 2001B with a DYN-001 motherboard. The issue was related to the NEC/TOKIN capacitors, and I diagnosed it using the SYSCON, which was showing a lot of 3004 errors.
After replacing the components, I ran some basic tests and everything seemed to work fine.
Then I decided to clean the motherboard and reassemble the console.
However, after reassembly, the power button stopped working.
I checked the flat cable and it appears to be fine.
So I connected to the SYSCON again and used the bringup command — the PS3 powered on and worked normally.
Does anyone know what might be causing this issue?
Just to clarify the eject button works normally, only the power button is unresponsive.
Yesterday I repaired a PS3 model 2001B with a DYN-001 motherboard. The issue was related to the NEC/TOKIN capacitors, and I diagnosed it using the SYSCON, which was showing a lot of 3004 errors.
After replacing the components, I ran some basic tests and everything seemed to work fine.
Then I decided to clean the motherboard and reassemble the console.
However, after reassembly, the power button stopped working.
I checked the flat cable and it appears to be fine.
So I connected to the SYSCON again and used the bringup command — the PS3 powered on and worked normally.
Does anyone know what might be causing this issue?
Just to clarify the eject button works normally, only the power button is unresponsive.
Last edited by a moderator:
