Starship2
Member
Hey guys,
i was messing around with fantables in my slim consoles and came to the conclusion that my fantables do not change anything to the fan behaviour.
On the first console i wrote paco's fantable to 2c0 and the fan behaviour is still the same as stock. When i do r 2c0 1a it perfectly shows what i have written to it, but the syscon doesnt follow my table. However, after messing around with console 1 its not possible to connect via uart to syscon. I exited via exit command and since then im not able to auth, it always refuses with "auth1 response invalid". Whatever, now i took the second slim (same model, 2004b, dynamo01) and wrote my own fantable to it. And same thing, it doesnt follow that table.. fan works alway with stock speeds..
where is my mistake, what am i missing here?
i wrote the following tables to it:
RSX
w 2c0 40 31 00 00 00 48 31 80 2f 00 4d 37 00 31 00 5a 37 00 34 00 80 3f 80 3d 80
Cell
w 250 40 37 00 2f 00 48 39 00 31 80 4d 3d 80 37 00 5a 3f 80 3d 80 80 43 80 3f 00
These should make a noticeable difference as they are pretty aggressive curves, but at 73degrees Celsius on both chips the fan is running at 29% what looks stock to me.
Both consoles ignore what is written to syscon.
r 7fe 2 is FE 7B
eepcsum is 7BFE so everythings fine.
Does anyone know whats the problem?
i was messing around with fantables in my slim consoles and came to the conclusion that my fantables do not change anything to the fan behaviour.
On the first console i wrote paco's fantable to 2c0 and the fan behaviour is still the same as stock. When i do r 2c0 1a it perfectly shows what i have written to it, but the syscon doesnt follow my table. However, after messing around with console 1 its not possible to connect via uart to syscon. I exited via exit command and since then im not able to auth, it always refuses with "auth1 response invalid". Whatever, now i took the second slim (same model, 2004b, dynamo01) and wrote my own fantable to it. And same thing, it doesnt follow that table.. fan works alway with stock speeds..
where is my mistake, what am i missing here?
i wrote the following tables to it:
RSX
w 2c0 40 31 00 00 00 48 31 80 2f 00 4d 37 00 31 00 5a 37 00 34 00 80 3f 80 3d 80
Cell
w 250 40 37 00 2f 00 48 39 00 31 80 4d 3d 80 37 00 5a 3f 80 3d 80 80 43 80 3f 00
These should make a noticeable difference as they are pretty aggressive curves, but at 73degrees Celsius on both chips the fan is running at 29% what looks stock to me.
Both consoles ignore what is written to syscon.
r 7fe 2 is FE 7B
eepcsum is 7BFE so everythings fine.
Does anyone know whats the problem?
