stuck in update loop Error 8002F14E

[Yo_Yo]

Hi, I have a CECHA01 I have been trying to resurrect. I knew the Bluray drive was defective when I got it. I cleaned it, repasted it, and changed the battery. Then I tried to set the clock from the internet and got error 80710A06. Went to update got error 8002F14E. Now I'm stuck in a loop at 88% then reset.

working in a CECHH01 For a temporary swap if needed. I just need to get to CFW. I'm afraid If i swap the drive if it will mess up that system that is currently working?

Do I have to swap in a new drive? is there a way to stop the loop and just upload a jailbreak?

 

[Coro]

Hi, I have a CECHA01 I have been trying to resurrect. I knew the Bluray drive was defective when I got it. I cleaned it, repasted it, and changed the battery. Then I tried to set the clock from the internet and got error 80710A06. Went to update got error 8002F14E. Now I'm stuck in a loop at 88% then reset.

working in a CECHH01 For a temporary swap if needed. I just need to get to CFW. I'm afraid If i swap the drive if it will mess up that system that is currently working?

Do I have to swap in a new drive? is there a way to stop the loop and just upload a jailbreak?

you check error codes HERE

8002F14E says -> Error with installing Firmware update. (BD)Drive not found or disconnected. // or CoreOS region failure when in log "Update Core OS Package done(0x8002f14e)" or Revoke region failure when in log "Update Package Revoke list done(0x8002f14e)"

check the cables of bdvd drive.

 

[Yo_Yo]

Thank you. I have already checked all connections several times, they seem to be good. I thought it was the Bluray drive. I have the top of the Blu-ray drive off right now. I can see the laser power on and move. At 88% it starts moving. almost like it's trying to load but can't, so moves maybe 2mm in each direction over and over until reboot.

I don't know what other troubleshooting steps that I can take.

 

[DeViL303]

It sounds like BD drive not attached properly, maybe connector or ribbon cable damaged. Do not assume its connected properly just because it moves or lights come on etc. There are a lot of small pins and they all need to be making a good connection.

 

[Yo_Yo]

It sounds like BD drive not attached properly, maybe connector or ribbon cable damaged. Do not assume its connected properly just because it moves or lights come on etc. There are a lot of small pins and they all need to be making a good connection.

Thank you! I actually just got it to finish the update. I took the drive apart like 10 times for like 6 hours. I finally went through and checked every single connection. I guess something was not fully connected as you said. The system was a mess when I got it. Who knows what they did. I guess they were trying to get the disk out but never succeeded. Just glad I was able to bring it back to life.

 

[Kleon1876]

mine gets struck at %6, does that mean its not the BD? i have a 3001B, everything seems connection, BD takes disk, laser comes on. error 8002F14E

Update Package Revoke list read package revoke list package (576 bytes) elapsed = 6 msec update package revoke list elapsed = 331 msec Update Package Revoke list done(0x8002f000)	RL_FOR_PACKAGE.img copied from PUP to trvk_pkg
Update Core OS Package read core os package (5193774 bytes) elapsed = 324 msec update core os package elapsed = 1965 msec Update Core OS Package done(0x8002f000)	Core OS package (CORE_OS_PACKAGE.pkg) is unpkg'ed from PUP and written to ros